GNX THQ (Throttle Quadrant)

GNX THQ (Throttle Quadrant)

A USB connection is not included by default because GNX modules are specifically designed to be connected to Gladiator NXT/EVO joysticks, allowing them to function together as a single integrated device through their internal BUS interface.

If you want to use a GNX module on its own, directly connected to your PC, you'll need to separately purchase and install a GNX USB Controller HID-Main to replace the module's default GNX BUS Interface.

Included

• THQ Module
• Plastic Coupler
• Type-C Connector Guard
• Rubber Pads
• Plastic Spacers
• Interchangeable Heads
• Metal Levers (Long)
• Plastic Levers (Short)
• Internal "Module-to-Module" Cable
• Internal "Module-to-Joystick" Cable
• Phillips Screwdriver
• HEX Screwdriver
• Stickers with Protective Film

Tabletop module

A GNX tabletop module can be attached side-by-side to the following devices:

• Gladiator NXT/EVO joystick base (from either side)
• Gladiator NXT EVO Omni Throttle (from the opposite side of the OTA elbow)
• SEM modules (up to a total of 4 SEM modules)
• THQ modules (up to a total of 4 THQ modules)

Recommendation

• If you want to use a GNX module on its own, directly connected to your PC, you'll need to separately purchase and install a GNX USB Controller HID-Main to replace the module's default GNX BUS Interface.

Features

Utilizes the newly developed VKB Njoy 32NG firmware, allowing recognition of up to 20 analog axes in Windows, divided into 3 devices.

• 3 Analog Axes (with clutch dampers and adjustable length/height of axis levers)
• 8 Push Buttons
• 5 Interchangeable Axis Lever Heads (different colors/shapes)
• Connect up to 4 GNX THQ modules, providing a total of 12 analog axes